For our F10 install – Please review the following videos and let me know if you have any questions!!
Step 1 – BREAK DOWN THE SYSTEM
***Before The Mode drive the vertical axis of the Nidek to the top of it’s range using the joystick, then power the system OFF but leave plugged in***
Remove front cover
Remove Top Cover
Remove Side Covers
Remove Operator Bottom Cover
Remove Base Front Cover
Tilt Out Front Display Screen
Almost Done with removing things!!!
Control Board Removal
Removal A:
Removal B
Interlock Bypass Procedure
Cable Removal / Replacement
Control Panel Cable Disconnect 1
Control Panel Cable Removal (Last Step)
Drive Cable Installation
Drive Cable Pin Installation A
Drive Cable Pin Installation B
Modified Cable Install Step 1
Modified Cable Install Step 2
Modified Cable Install Last Step!
TEST SYSTEM! This confirms we didn’t break anything…Yet 🙂
Pre-Power Checks
Power Up and check replacement cable
Installation of Drive cable
Cable Routing
Pin Connections A
Pin Connections B
Pin Connections C
Gain Cable Connection
***WARNING! DO NOT FOLLOW THIS GUIDE COMPLETELY! INSTEAD WATCH MY COMMENTED AREAS ON THE VIDEO!!!***
Gain Wire Routing and connection to drive cables
Now we can test our modification!
First, download and install the Arduino Suit and Driver software from here:
Second – install the software and accept the driver certification request
Third – connect the External control cable to the new control box, and connect the USB cable from the box to the PC.
Fourth – Confirm in the Windows Device manager that the box connected by checking the COM ports. You should see “Arduino COMXXX”
Fifth, Open the Arduino IDE software, under Tools, select “serial port” and select the Com # for your board.
Sixth, Under Tools, select “board” and select “Mega 2650 ADK”.
Next click on the magnifying glass in the upper right of the program to launch the serial port monitor, and to check if we have a good connection. Sending a STATUS? command should return text. ***The serial monitor should be connected at 9600 Baud (selection box in the serial monitor window on the lower right corner).
Now, we can proceed to testing!
Testing Focus
Testing FA Mode
Testing Gain
Leave a Reply